Walk-in cooler temperature sensor replacement and condenser cleaning — Denver
A walk-in cooler in Denver needed diagnosis of its controls. The fix was a new temperature sensor and a deep cleaning of the condenser coil.

The problem
The control board decides when the walk-in runs and defrosts based on its sensors. A failing sensor gives it the wrong picture.
A dirty condenser coil makes the system work harder and run hotter, and it adds to whatever else is wrong.
What we did
- Ran diagnostics on the control board and checked its display readings.
- Checked compressor amperage with a clamp meter.
- Checked the pressure control and wiring against the unit's wiring diagram.
- Replaced the temperature sensor.
- Deep-cleaned the condenser coil.
Result
With the new sensor and a clean coil, the control board was working from correct readings again.
Takeaway for operators
On electronically controlled walk-ins, check the sensors before replacing the board, and clean the coil while you are there.
Similar problem with your equipment?
Same- or next-day appointments, written quote before any work, EPA 608 certified technicians.
More case studies
Walk-in beverage cooler with two iced-up evaporators
A convenience store in northeast Denver called about its commercial walk-in cooler.
Read →October 2026Walk-in cooler condensing unit service
A store in northeast Denver had its walk-in cooler checked from the evaporators inside the box to the condensing unit outside.
Read →July 2026Walk-in cooler start capacitor replacement
A Denver business called about its Masterbilt walk-in cooler.
Read →September 2026Walk-in cooler compressor replacement on a café rooftop
A café in Aurora lost cooling in its walk-in cooler.
Read →September 2026Walk-in cooler restored by deep coil cleaning
A pizza kitchen inside a truck-stop building in Commerce City needed service on its walk-in cooler.
Read →June 2025Keg cooler defrost and controller repair
A cidery in Longmont called because its keg cooler was not holding temperature.
Read →




