Home / Commercial appliances / Commercial Ovens & Ranges

Commercial equipment

Commercial oven and range repair in Denver

Convection ovens that heat unevenly or smoke, gas ranges with pilots that won't stay lit, countertop ovens that take forever, and food warmers that shut themselves off. We repair commercial cooking equipment for Denver restaurants, cafés, schools and kitchens.

Commercial service call$129
Waived when you approve the repairWritten quote before any work · same- or next-day appointments · 90-day warranty on parts and labor

4.8 ★  71 Google reviews

Request business service

We reply during business hours (Mon–Sat 7am–7pm · Sun 8am–6pm). Urgent? Call (720) 534-0432.

Same / next-day dispatchPriority slots for contract clients
90-day warrantyOn every repair, parts and labor
Service call waivedWhen you go ahead with the repair
EPA 608 certifiedTechnicians licensed for refrigerant work
Insured, COI on requestReady for vendor onboarding
W-9 & invoicingNet-30 terms for approved accounts

Commercial ovens and ranges are simpler than home units but they work far harder. Most of the failures we see in Denver kitchens are thermostats and thermocouples on gas equipment, elements and power cords on electric countertop ovens, convection blower problems, timers, and broken door glass.

Below are real commercial cooking repairs from our job records in and around Denver, with photos from those jobs. We work on convection ovens, restaurant ranges, countertop ovens, pizza ovens and holding equipment. We don't service fryers or grills.

Gas ranges

Gas restaurant ranges: pilots, thermocouples and thermostats

01A Denver kitchen range that wouldn't hold temperature

The oven on a commercial gas range in a Denver kitchen wasn't heating properly. The oven thermostat, the thermocouple and the pilot assembly had all worn out. We replaced all three and calibrated the oven temperature against a thermometer before handing it back.

Commercial gas range in a Denver kitchen
Commercial gas range in a Denver kitchen
Range oven after the thermostat and pilot repair
Range oven after the thermostat and pilot repair

02Pizza ovens

On a gas pizza oven in Arvada the flame was weak and kept dropping out. We cleaned the thermocouple and the clogged gas burner ports and tested the flame and safety shutoff.

Gas pizza oven
Gas pizza oven
Convection ovens

Convection ovens: blowers, timers and glass

03Imperial double convection oven smoking

An Imperial double-stack convection oven in Broomfield was smoking. The lower blower wheel had shifted on the motor shaft and was rubbing. We repositioned the blower relative to the motor and replaced the failed timer, then ran both ovens.

Imperial double convection oven
Imperial double convection oven

04Blodgett convection oven glass in Denver

The inner door glass on a Blodgett convection oven in a Denver kitchen had broken. We replaced the inner glass door assembly so the oven could hold heat and pass inspection again.

Blodgett convection ovens in a Denver kitchen
Blodgett convection ovens in a Denver kitchen
Countertop ovens

Countertop ovens that heat slowly

05Moffat Turbofan in Boulder

A Moffat Turbofan countertop oven used for cooking classes was taking far too long to heat. The element should measure 28.8 ohms and read about 9, so it had failed. We also found a damaged power plug and a broken ground connector. We replaced the element and the power cord and calibrated the thermostat.

Moffat Turbofan countertop oven
Moffat Turbofan countertop oven
Holding equipment

Food warmers and pizza tables

06Food warmer shutting off in Lakewood

A food warmer in a Lakewood restaurant kept shutting itself off. It had been run at a very high setting, which tripped the high-limit thermostat, and the controls wouldn't let the staff turn it down. We cleaned the contactor relay contacts and replaced the high-limit thermostat.

Food warmer back in service
Food warmer back in service
Job records

Recent commercial ovens & ranges repairs in and around Denver

WhereApplianceProblemWhat we did
DenverCommercial gas rangeOven not heating properlyReplaced thermostat, thermocouple and pilot, calibrated
DenverBlodgett convection ovenBroken inner glassReplaced inner glass door assembly
BroomfieldImperial double convection ovenSmokingRepositioned lower blower, replaced timer
BoulderMoffat TurbofanHeating very slowlyReplaced element and power cord, calibrated thermostat
ArvadaGas pizza ovenWeak flameCleaned thermocouple and burner ports
LakewoodFood warmerShutting offCleaned contactor contacts, replaced high-limit thermostat

Problems are described as the customer reported them; repairs are taken from the technician's notes. No customer details are published.

Tips from our technicians

How to avoid the next commercial ovens & ranges repair

Check oven temperature weekly with an oven thermometer and write it down. Drift shows up long before the oven fails.

Keep pilot and burner areas free of grease and flour; clogged ports cause weak flames and pilot outages.

Don't run holding equipment at maximum. It trips high-limit thermostats.

Have convection fans checked if you hear rubbing or scraping, or see uneven browning.

Replace damaged power cords and plugs immediately; they're a fire risk.

Who we are

ABC Denver Appliance Repair is an independent, local repair company. Our technicians are EPA 608-certified, carry common parts on the truck and test every repair before they leave. Every repair comes with a 90-day parts and labor warranty.

Problems we fix

Common commercial ovens & ranges problems we fix

If you smell gas, stop and call the gas utility first

If you smell gas, do not light anything, do not operate switches, get people out of the building and call your gas utility or 911 from outside. An appliance repair visit is not the right first call for a suspected gas leak. Once the utility has made the area safe, we can diagnose and repair the equipment, and all gas appliance work is done in line with applicable codes.

Book a technician

Commercial oven not heating or heating unevenly

Gas ovens that will not heat often have a failed igniter, flame sensor or thermocouple, a bad gas valve or a control fault; uneven baking in a convection oven often means a failing convection fan motor, a worn blower wheel or a door that is not sealing. The technician checks ignition, the safety circuit and the fan, then verifies cavity temperature with a separate thermometer.

From our jobs

Oven temperature verification after the repairMoffat Turbofan convection oven in a school kitchenCommercial gas range in a synagogue kitchen, oven open for serviceTen-burner commercial range with both ovens open

Book a technician

Oven temperature off from the dial

If product burns or stays raw at the usual setting, the thermostat or temperature probe may be out of calibration, or the control may be failing. We measure actual cavity temperature, calibrate mechanical thermostats where possible, and replace probes, thermostats or controls that cannot hold their setting.

From our jobs

Oven section of the commercial range during thermostat workRange oven open for thermostat testingOven section of the 60-inch gas rangeBlodgett double-stack convection ovens at a bakery

Book a technician

Range pilot light will not stay lit

A pilot that lights but goes out when you release the knob usually points to a weak or failed thermocouple, a dirty pilot orifice or a poorly positioned flame. We clean the pilot assembly, test the thermocouple output and check the safety valve. Pilots that keep going out should never be overridden or propped open.

Book a technician

Burners not lighting or lighting with a pop

Burners that are slow to light or ignite with a pop often have clogged burner ports, a misaligned flash tube, a dirty pilot or a weak spark igniter. We clean and align burner parts, test the ignition system, and check that the flame is stable and the right color.

Book a technician

Yellow or sooty burner flames

A lazy yellow flame, soot on pans or a strong odor while cooking can mean poor combustion from dirty burners, incorrect air shutter settings, or orifices not set up correctly for the gas type or for altitude. Gas appliances at Front Range elevations may need adjustment from sea-level settings. We inspect and adjust per the manufacturer's instructions and applicable code.

Book a technician

Griddle hot and cold spots

Uneven griddle plates usually come from a failed burner section, a clogged burner, or a bad thermostat on thermostatic griddles. We check each zone's flame or element, verify plate temperature across the surface with a surface thermometer, and look for a warped plate, which no burner repair will fix.

Book a technician

Charbroiler not getting hot enough

Weak broiler heat is often caused by clogged burners from grease and debris, damaged radiants, a low-pressure gas supply or a failing valve. We clean and inspect burners and radiants, check valve operation and look for supply issues to pass on to your gas contractor if needed.

Book a technician

What we service

Equipment covered

Tell us the type of equipment, gas or electric, and what is happening, and confirm there is no gas smell before the visit. The technician inspects ignition, safety and gas control components, checks actual temperatures with a test instrument, and gives you a written quote before work begins. Gas work is performed to code, with the equipment's gas shutoff and connections checked as part of the job. Ignition parts, thermocouples and common thermostats are carried on the truck, so many line equipment repairs are finished before the next service.

  • Commercial gas and electric ranges
  • Convection ovens (full-size and half-size)
  • Range ovens and standard bake ovens
  • Deck and pizza ovens
  • Flat-top griddles (manual and thermostatic)
  • Charbroilers and radiant broilers
  • Hot plates and stock pot ranges
  • Salamanders and cheesemelters
  • Countertop cooking equipment

Between visits: what your staff can do

  • Clean burner grates, ports and drip trays daily so grease and debris do not clog burners.
  • Check oven temperature against a separate oven thermometer every few weeks and note any drift.
  • Keep oven door gaskets and hinges in good shape; a door that does not seal wastes heat and cooks unevenly.
  • Make sure the hood and its filters are cleaned on schedule and that nothing blocks combustion air under the equipment.
  • Never bypass a pilot safety or prop open a gas valve, and report any gas odor immediately.
  • Keep the equipment's restraining cable and flexible gas connector in place when moving equipment to clean behind it.

Repair or replace?

Igniters, thermocouples, thermostats, probes, valves and fan motors are standard repairs and usually well worth doing. When an oven cavity is rusted through, a griddle plate is warped, or a range body is cracked and burners are rusting out, repair costs climb while results stay poor. We will tell you honestly when a piece of equipment has reached that point, and give you the repair price in writing either way so you can compare it with a replacement quote from your equipment dealer.

Who we do this for

Brands

Commercial Ovens & Ranges brands we repair

How a service call works

Step 1

Request

Call, text or send the form. Tell us the location and the equipment.

Step 2

Diagnose & quote

A technician arrives same or next day and gives a written quote before any work.

Step 3

Repair & report

You get a photo report and an invoice your office can file the same day.

Commercial Ovens & Ranges: common questions

My commercial oven won't hold temperature. What is it?

On gas: the thermostat, thermocouple or pilot. On electric: the element, thermostat or a contactor. We test and calibrate before replacing.

My convection oven is smoking or making a scraping noise. Is it safe?

Turn it off. A blower wheel rubbing on the housing or a failing motor can damage the oven. It's usually a same-visit adjustment or part.

Do you repair commercial fryers and grills?

No. We repair commercial ovens, ranges, countertop and pizza ovens and holding equipment, along with refrigeration, ice machines, dishwashers and laundry.

Can you calibrate my oven?

Yes. We calibrate thermostats against a reference thermometer on every oven we repair.

How fast can you come?

Commercial calls get priority. We offer same- or next-day service across the Denver metro; call and we'll give you the soonest time.

Call (720) 534-0432