Defrost sensor error
TechnicianThe evaporator (defrost) sensor is faulty or disconnected.
Causes the manufacturer lists
- Defective or disconnected evaporator sensor
Home / Error codes / Danfoss
Refrigeration controllers · 12 codesElectronic refrigeration controllers used on bottle coolers, reach-ins and display cabinets. Covers: ERC 211, ERC 213, ERC 214 (ERC 21x series)
The display alternates between the air temperature and the active alarm/error code; an alarm bell icon lights.
Alarms show until the condition is resolved. A61 clears when condenser temperature drops 5 K below the limit. A80 needs a manual reset: set r12 to OFF and back ON, or power the controller down.
If the same code comes back after a reset, stop resetting it — repeated restarts can hide the real fault or damage components. Call a technician.
The evaporator (defrost) sensor is faulty or disconnected.
Causes the manufacturer lists
The cabinet air temperature sensor is faulty or disconnected.
Causes the manufacturer lists
What staff can safely check
The condenser temperature sensor is faulty or disconnected.
Causes the manufacturer lists
Cabinet air temperature is too high.
What staff can safely check
Cabinet air temperature is too low.
What staff can safely check
The door has been open too long.
Causes the manufacturer lists
What staff can safely check
An external alarm signal has been received on a digital input.
Control has been stopped with the main switch setting (r12), so the unit is not cooling.
Causes the manufacturer lists
Condenser temperature is too high; the manual says to check airflow.
Causes the manufacturer lists
What staff can safely check
Condenser temperature has gone too high and the controller has locked out; a manual reset is required.
Causes the manufacturer lists
What staff can safely check
Supply voltage is too high; compressor protection is active.
Causes the manufacturer lists
Supply voltage is too low; compressor protection is active.
Causes the manufacturer lists
What staff can safely check
Same- or next-day appointments across the Denver metro. Written quote before any work, EPA 608 certified technicians.
Other displays: -d- defrost in progress, Pud pull-down, Err temperature can't be shown due to sensor error, Loc/UnL keypad locked/unlocked, OFF control stopped. Danfoss EKC models use different codes and are not covered here.
Compiled and paraphrased from the manufacturer documents above. Codes differ between model years and control boards — confirm against the manual for your exact model. ABC Denver Appliance Repair is an independent service company, not affiliated with Danfoss.