Home / Error codes / Scotsman

Ice machines · 15 codes

Scotsman Prodigy Ice Machine Codes

Prodigy and Prodigy Plus modular cube ice machines (C-series). Covers: Prodigy / Prodigy Plus controller with single-character code display (C2648 service manual, Jan 2015). Prodigy ELITE not verified.

Commercial service call$129
Waived when you approve the repairWritten quote before any work · same- or next-day appointments · 90-day warranty on parts and labor

How the codes appear

A single character on the controller's code display shows the machine's status or the reason it shut down; some codes flash to show the controller is retrying before it locks out.

Resetting

Manual reset after a shutdown: open the switch door, press and release Off, then press and release On. To turn the machine off, hold Off for 3 seconds. After a water or power outage the machine restarts by itself; if power to a remote condenser was cut while the ice machine stayed powered, it may need a manual reset.

If the same code comes back after a reset, stop resetting it — repeated restarts can hide the real fault or damage components. Call a technician.

Scotsman code list

1

Max freeze time shut down

Technician

The freeze cycle hit the maximum freeze time (45 minutes). The controller retries (a flashing 1 means it is retrying); after three consecutive long freezes the machine shuts off and needs a manual reset.

2

Max harvest time shut down

Technician

Harvest hit the maximum time (3.5 minutes) without the curtain opening. The machine waits 50 minutes and restarts, up to 2 automatic retries (flashing 2); a third consecutive failure needs a manual reset.

3

Slow water fill

Status / staff can check

The reservoir took longer than the maximum fill time (8 minutes) to fill. The machine tries to restart every 20 minutes.

Causes the manufacturer lists

  • Lack of water supply to the machine

What staff can safely check

  • Check whether water to the machine or building was shut off; the manual says the machine restarts on its own within about 25 minutes after water is restored
4

High discharge temperature

Technician

Compressor discharge temperature exceeded the controller's limit (250°F), so the machine shut down.

5

Sump temperature sensor failure

Technician

The controller detected a failed sump (water) temperature sensor.

7

Discharge temperature sensor failure

Technician

The controller detected a failed discharge temperature sensor.

8

Short freeze, thin ice

Technician

Harvest was triggered too soon after the minimum freeze time (6 minutes), producing thin ice. A flashing 8 means it is retrying; if it recurs within the next three cycles the machine shuts down and needs a manual reset.

E

Self test failed

Technician

The controller failed its power-up self check and will not run.

b

Bin is full

Status / staff can check

Normal status: the bin is full and the machine is waiting. A curtain held open by stuck ice also stops the machine.

What staff can safely check

  • If the bin is not actually full, check whether ice is stuck under a curtain and holding it open; remove the ice and the machine should restart within a few minutes
F / flashing F

Freeze cycle / freeze pending

Status / staff can check

Normal status: freeze cycle running (flashing = freeze about to start).

H / flashing H

Harvest cycle / manual harvest

Status / staff can check

Normal status: harvest running (flashing = manual harvest).

C

Clean cycle

Status / staff can check

Normal status: cleaning cycle in progress.

L

Board locked

Status / staff can check

The controller's buttons are locked.

d

Test mode

Status / staff can check

The controller is in test mode.

O

Off

Status / staff can check

The machine is switched off (standby).

Seeing Scotsman codes you can't clear?

Same- or next-day appointments across the Denver metro. Written quote before any work, EPA 608 certified technicians.

Request service

Model notes

Codes 6 and 9 are not listed. Timing limits are from the C2648 manual's control-safeties table; other Prodigy sizes may differ slightly. The manual lists general shutdown reasons (no water, long freeze, long harvest, high discharge temp, self-test failure, very high voltage) but per-code cause lists were not found in the pages reviewed, so common_causes are left empty. Official PDFs on scotsman-ice.com (incl. Prodigy ELITE service manual) could not be parsed, so Prodigy ELITE codes are unverified. Sources are manualsdir-hosted copies of the Scotsman manual.

Sources

Compiled and paraphrased from the manufacturer documents above. Codes differ between model years and control boards — confirm against the manual for your exact model. ABC Denver Appliance Repair is an independent service company, not affiliated with Scotsman.

From our job records

Photos from our job records

Real photos our technicians took on calls around Denver and the Front Range. Each caption says what was done; no customer details are shown.

Panel-ready Jenn-Air refrigerator in a Westminster kitchen
Panel-ready Jenn-Air refrigerator in a Westminster kitchen
Dacor gas cooktop after the spark module replacement
Dacor gas cooktop after the spark module replacement
Wolf double oven in Lyons after light and fan switch replacement
Wolf double oven in Lyons after light and fan switch replacement
Open-air food and beverage cooler at a Littleton business
Open-air food and beverage cooler at a Littleton business

Call (720) 534-0432