At power up
Status / staff can checkShown at power up.
Home / Error codes / Speed Queen
Commercial laundry · 5 codesSpeed Queen commercial gas tumble dryers. Covers: Gas ignition control diagnostic LED on dryers covered by manual 70693301 (030 through 200 lb series; Dual Digital, Quantum Gold and Quantum Touch controls)
Red diagnostic LED on the ignition control flashes a count (1/4 s on, 1/4 s off, 3 s pause between codes).
Manual says a control in lockout needs a manual reset (start button with service door open on single machines, or programming connector open on stack machines); it does not explicitly tie this to a specific flash code.
If the same code comes back after a reset, stop resetting it — repeated restarts can hide the real fault or damage components. Call a technician.
Shown at power up.
The control senses a flame when no heat is being called for.
The ignition control has locked out after failing to light.
Manual reset error on the ignition control.
The ignition control has failed internally; all outputs turn off. If it persists after a restart attempt the control must be replaced.
Causes the manufacturer lists
Same- or next-day appointments across the Denver metro. Written quote before any work.
These are ignition-control LED codes, not the Quantum/Quantum Touch display error codes. Quantum display error codes could not be retrieved from an official document.
Compiled and paraphrased from the manufacturer documents above. Codes differ between model years and control boards — confirm against the manual for your exact model. ABC Denver Appliance Repair is an independent service company, not affiliated with Speed Queen.
Real photos our technicians took on calls around Denver and the Front Range. Each caption says what was done; no customer details are shown.